Setting The Stroke Depth; Changing The Engraving Tips - Parkside PGG 15 E4 Operating Instructions Manual

Setting the stroke depth

You can use the stroke rate control
engraving . A low setting is usually sufficient for the most common
applications .
♦ Turn the stroke rate control
depth .
♦ Turn the stroke rate control
depth .

Changing the engraving tips

CAUTION! RISK OF INJURY!
► Switch the appliance off and remove the power plug before com-
mencing any work to the appliance .
♦ Change the engraving tip
longer delivers the desired engraving results . Turn the engraving tip
lock anticlockwise until the engraving tip
♦ Remove the spring and washer .
♦ Slide the washer and spring onto a new engraving tip
it into the appliance and turn the engraving tip lock
lock the tip .
♦ Ensure that the engraving tip
■ 10 │ GB │ IE │ NI │ CY
to adjust the depth of the
towards the + to increase the stroke
towards the – to decrease the stroke
as soon as it becomes worn and no
is fixed correctly in place .
can be removed .
. Then insert
clockwise to
PGG 15 E4