Before First Use - Telefunken VCBH5 Manual

Before first use

1. Place your appliance on a flat and stable surface. Your heater is equipped with tip over
switch which will automatically switch it off if not on place on stable surface.
2. Ensure to place the heater at least 100 cm from the walls, furniture and curtains.
3. Plug your appliance into a earth socket.
4. Before the first use, always heat up the heater to burn the protective fat and to eliminate
smells when you buy new appliances. Follow the steps indicated in the section « Using
your appliance » to switch on the heater.
NOTE: It is normal that strange odor comes out from the unit for the first use. This will
cease after a short while. Do not forget to air the room during this operation.
This heater is equipped with Digital Controls that provide the ability to set the temperature to
the exact degree desired .To operate, simply follow these instructions and the control panel:
The display shows the temperature of the area around the product (diagrams below)
There may be a difference of temperature indication, between that of the heating zone and that
of the part. This difference is reduced during a continuous operation of the radiator.
3
NOTE: The temperature
display will not reflect
the accurate
temperature until the
heater has
operating for at least 30
minutes.
ENGLISH
room
been