Getting Connected - VocoPro Commander Series User Manual

Getting Connected:

Commander HT
The Commander-HT (
requires any of the corresponding receiver models in
order to operate: Commander-HR, Commander-PR,
or Commander-UR*
• Insert fresh batteries.
• Power ON the Commander-HT by pressing the
Power Button once
(a green power LED light will now be visible)
Note: A flashing green LED indicates low battery.
• If the Commander HT does not automatically sync
(connect) to one of the Commander receivers,
press the FREQ button and check for a solid AF
light on the receiver.
shown for illustration purposes only.
Commander CT
The Commander-CT
requires any of the corresponding
transmitter)
receiver models:
Commander-HR, Commander-PR, or
Commander-UR*
• Connect Commander HM or a condenser/ high
impedance style microphone to the 3.5mm jack.
• Power ON the Commander-CT by pressing the
Power Button once (a blue power LED light will
now be visible).
• Adjust output volume on your microphone (if
applicable) and the volume of the Commander-CT.
• Speak into the microphone and verify that the
AF LED is showing the Commander-CT is in fact
receiving audio input signal.
*Please reference the frequency groupings guide in the technical
specifications section of this manual for correct pairings.
16 \
wireless handheld microphone)
Note: Receiver is not included and is
(wireless condenser microphone
Continues on page 17