Epson EB-755F Installation Manual page 73

Setting the Projector
b
Connect the USB flash drive to the projector's USB-A port
c
•
Connect the USB flash drive directly to the projector. If the USB flash drive is connected to the
projector through a USB hub, the settings may not be saved correctly.
•
Connect an empty USB flash drive. If the USB flash drive contains data other than the batch setup
file, the settings may not be saved correctly.
c
While holding down the [Esc] button on the remote control or the control panel, connect
the power cord to the projector
The On/Standby indicator and the Status indicator turn blue, and the Laser indicator and the Temp
indicator turn orange.
When all of the projector's indicators turn on, release the [Esc] button.
When all of the indicators start flashing, the batch setup file is being written.
Caution
•
Do not disconnect the power cord from the projector while the file is being written. If the power cord
is disconnected, the projector may not start correctly.
•
Do not disconnect the USB flash drive from the projector while the file is being written. If the USB flash
drive is disconnected, the projector may not start correctly.
When writing completes normally, the projector turns off, and only the On/Standby indicator is lit blue.
When the power turns off, remove the USB flash drive.
c
•
The file name for the batch setup file is PJCONFDATA.bin. If you need to change the file name,
add text after PJCONFDATA. If you change the PJCONFDATA section of the file name, the
projector may not be able to recognize the file correctly.
•
You can only use single-byte characters for the file name.
72