Zoom 4403 Setting Up page 6

Wireless-n 4-port router setting up as a repeater or as a wireless bridge

Hide thumbs Also See for 4403:

Important! Your base router (also called AP or Access Point) needs to be set up properly to work

with the Repeater. Go into the Wireless section of the base router's configuration page. Turn WDS

on, enable Wireless Repeater, and enter the wireless MAC address of the Model 4403 Repeater. (You

wrote this down in step 2 above.) Make sure that the base router is using the same security type as

the Model 4403 Repeater. (This is normally WEP.) If the base router is using WEP security, the base

router's security key should be the same as the model 4403 Repeater's security key.

Note: If you disabled DHCP on the Model 4403 Repeater, reboot any computers that connect to the

Model 4403 Repeater through its Ethernet port or wirelessly. This ensures that the computers

receive the proper IP address from your base router.

If you had to unplug any cables or make any changes to the computer that you used to configure

Model 4403, you now should restore that computer back to its original state.

Congratulations! Your Model 4403 is now setup in Repeater mode and your base router is configured to work

with it.