Adjust Signal Level; Component Level Adjustments; Adjust X2 Component Level; Adjust 15K Rgb Level - Sony VPL-FX50 Manual

3-4. Adjust Signal Level

3-4-1. Component Level Adjustments

1. Input the Component signal to the INPUT-A. Then,
from INPUT-A of the SET SETTING, select the
COMPONENT (15K Component color bar chroma
ON).
2. Set the COLOR to 50.
3. Connect the Oscilloscope to the TP5305 (B OUT) of
the C board .
4. Enter the item OTHER of Device Adjust of the menu.
5. Set 06 3D GAMMA/ THROUGH : 0 to 06 3D GAM-
MA/ THROUGH : 1.
6. Set 07 3D GAMMA/ SW : 1 to 07 3D GAMMA/ SW :
0.
7. Advance the item RGB-MTRX of Device Adjust of
the menu.
8. Select the item 08 YUV COL. Use the key ← or →, or
both, to adjust level of two color bars, the left and right
end so that they will come to the same level.
9. Select 09 SUB HUE, then adjust the level of centrally
adjoining two color bars in the midst of all bars, using
the key ← or →, or both so that they can be made flat.
10. Press ENTER key and select " SAVE TO MEMORY
". For saving the data, press the ENTER again.
(15K Component color bar/Chroma ON)
Fig. 3-4-1

3-4-2. Adjust X2 Component Level

1. Set the COLOR to 50.
2. Connect the Oscilloscope to the TP5305 of the C
board.
3. Input the Color bar signal 1080/60i 100% to the
INPUT-A. Select the DTV-YPbPr from the INPUT-A
of the SET SETTING.
4. Enter the item RGB MATRX of Device Adjust of the
menu.
5. Select the item 08 YUV COL. Use the key ← or →, or
3-2
Adjust GND to bottom ege
in the DC 0.5 V range.
both, to adjust the level of two color bars, the left and
right end so that they will come to the same level.
6. Select 09 SUB HUE, then adjust the level of centrally
adjoining two color bars in the midst of all bars, using
the key ← or →, or both so that they can be made flat.
7. Press the ENTER key and select " SAVE TO MEMO-
RY ".
8. For saving the data, press the ENTER key again.
(1080/60i 100% Color bar)
Fig. 3-4-2

3-4-3. Adjust 15K RGB Level

1. Set the COLOR to 50.
2. Connect the Oscilloscope to the TP5305 of the C
board.
3. Input the Color bar signal 15K RGB 100% to the
INPUT-A (5BNC). Select COMPUTOR from the
INPUT-A of the SET SETTING.
4. Enter the item RGB MATRX of Device Adjust of the
menu.
5. Select the item 08 YUV COL. Use the key ← or →, or
both, to adjust the level of two color bars, the left and
right end so that they will come to the same level.
6. Select 09 SUB HUE, then adjust the level of centrally
adjoining two color bars in the midst of all bars, using
the key ← or →, so that they can be made flat.
7. Press the ENTER key and select " SAVE TO MEMO-
RY ".
8. For saving the data, press the ENTER key again.
(15K RGB 100% Color bar)
Fig. 3-4-3
VPL-FX50