Sub Board-1 (R-Ch) - Sony WH-1000XM3 Service Manual

WH-1000XM3
2-7.

SUB BOARD-1 (R-ch)

• Continued on 2-8 (page 15).
relay cable
driver wire
3 Remove two solders
of the NTC thermistor.
(See Fig. A)
14
– –
1 wire sheet
(See Fig. D, E)
claw
2 Remove the battery wire,
relay cable and driver
battery wire
wire from the claw.
(See Fig. B, C)
Install each wire as shown figure below.
NTC thermistor
Install two solders of the NTC thermistor.
Push the relay cable inside
the claw and push the
driver wire from under it.
SUB
board
relay cable
Note: Handle the wire so as not cover the screw hole
with relay cable or driver wire.
Push the battery wire all the
way into the inside the claw.
SUB board battery wire
driver wire
SUB board
relay cable
SUB board
Sony CONFIDENTIAL
For Authorized Servicer
driver wire
Press.
Fold and bundle the relay
cable and driver wire.
Paste the
wire sheet.
SYS SET