Product Setup - D-Link DAP-1360 Quick Installation Manual

PRODUCT
SETUP
PC
AP
PRODUCT CONFIGURATION (WEB-BASED UTILITY)
To configure, open a web browser (such as Internet Explorer) and enter http://dlinkap or
http://192.168.0.50 in the address bar. This will direct you to the web-based configuration utility.
The default username is Admin and the password field should be left blank. Click Log In to
continue. Once logged in, click Launch Wireless Setup Wizard to commence the setup process.
For further information on configuring your access point, please refer to the included user manual.
If you have more than one Access Point, enter http://dlinkapxxxx (the xxxx are the last four digits
of the AP's MAC address which is located on the bottom of the device in the label).
4
POSITION THE RANGE EXTENDER
Place the range extender in an open area of your intended work area
for better wireless coverage. Please ensure that the access point is
within wireless range of the network which you wish to extend.
POWER ON RANGE EXTENDER
Plug the supplied power adapter into the back of the DAP -1360 and
connect it to a power outlet. Wait about 30 seconds for the device to
complete startup processes.
CONNECT THE DAP-1360
Using the included Ethernet cable, plug one end into the LAN port on
the back of the DAP -1360, and plug the other end into the Ethernet
port on your computer.
IP ADDRESS: http://dlinkap or http://192.168.0.50
USERNAME: Admin
PASSWORD: (blank by default)
DAP-1360