Mounting Bracket - Air King VAL30SS Important Instructions & Operating Manual

4. To install the optional top section, mark the location of the
included horizontal mounting bracket using the bracket as a
template. Make sure the bracket is level and in line with the
bottom section. The height will be dependent on your installation
requirements. Make sure the slots in the side of the chimney
will match the holes in the mounting bracket. Drill holes into
wall using a 1/4" drill bit. Install included wall anchors into holes
and secure bracket into place with two provided 3.19 x 32 mm
screws (Figure 8).
Mounting
Bracket
Figure 8
5. Raise top chimney in place over horizontal mounting bracket
and secure in place with the two included 3.5 x 9.5 mm screws
(Figure 8).
SECTION 6
Finishing the Installation
1. Install the appropriate filters.
Charcoal Filters: If the range hood will be run ductless install
model BCCF-01 charcoal filters on both sides of the motor.
This is done by lining up the keyhole slots of the filter with
the mounting post on the motor and pressing the filter into
place. Turn filter slightly, so that it locks into place (Figure 9).
Charcoal Filter
Figure 9
Grease Filters: Reinstall all grease filters by sliding tab at rear
of filter into slot in hood. Secure filter in place by tightening screw
located at front of filter. DO NOT OVERTIGHTEN (Figure 9).
2. Remove any protective plastic adhered to the range hood.
60804020 Rev A. 4-05
3. Turn switches to the OFF (
4. If there is any vibration noise, check for the source and try
SECTION 7
Operation
Controls
Your Range Hood is equipped with two sliding switches with one
controlling the lighting and the other controlling the exhaust fan.
The light control has two positions, ON (
fan is a four position control, HIGH (III), MEDIUM (II),LOW (I), and
OFF (
SECTION 8
Maintenance
CAUTION:
SERVICE PANEL BEFORE SERVICING THE UNIT.
Filters
Grease Filter
Cleaning
CAUTION:
HARSH CLEANSERS, ETC., AS THEY MAY DAMAGE THE RANGE
HOOD.
1. Clean your range hood with a mild detergent, such as
2. The fan assembly can be vacuumed when build up (dirt, lint,
www.airkinglimited.com
Test that the light and the fan are operating properly.
to tighten fasteners or adjust the tape to make a tighter
connection or seal.
) (Figure 10).
Figure 10
MAKE SURE POWER IS SWITCHED OFF AT
Grease Filter - Included with your range hood are aluminum
grease filters that should be washed at least once a month.
The filters are dishwasher safe and should be washed in a
mild soap or detergent. Refer to Step 3 of Section 1 Preparing
the Range Hood , to remove filters. If the grease filters become
damaged, replace with Air King Model BCGF-01 Grease Filter.
Charcoal Odor Filter - If you have installed the optional
charcoal odor filters, they cannot be washed and must be
discarded and replaced when they become noticeably dirty,
have stopped filtering the odors, or at least once per year.
Replace with Air King Model BCCF-01 Odor Filters.
DO NOT USE GASOLINE, BENZINE, THINNER,
dishwashing liquid, and dry with a soft cloth. NEVER USE
ANY ABRASIVE PADS OR SCOURING POWDERS. Completely
dry before restoring power. NEVER IMMERSE ELECTRICAL
PARTS IN WATER.
etc.) accumulates over time. The fan is permanently lubricated
and does not require oiling.
) position and restore power.
) and OFF ( ). The
4 of 20