Installing/Removing The Wind Screen - Mercedes-Benz AMG GT Roadster Operator's Manual

Soft top (Roadster)
82
The soft top is not locked if:
theOpen/Close Convertible Top Com‐ Open/Close Convertible Top Com‐
R
pletely pletely message is shown in the multifunc-
tion display
you hear a warning tone for up to ten seconds
R
when pulling away or while driving
Lock the soft top again if it is not locked fully:
Pull over and stop the vehicle safely as soon
X
as possible, paying attention to road and traf-
fic conditions.
Select SmartKey position 2 with the Start/
X
Stop button (
Y
Press the soft top switch (
X

Installing/removing the wind screen

Important safety notes
G
WARNING
If the wind screen is incorrectly installed, it
could detach itself during a journey and
endanger other road users. There is a risk of
an accident and injury.
Install the wind screen as described. Do not
place any objects on top of the installed wind
screen.
!
Install or remove the wind screen only when
the soft top is open. You could otherwise
damage the wind screen or the vehicle inte-
rior.
!
Mercedes-Benz recommends that you only
use wind screens which have been tested and
approved for Mercedes-Benz vehicles. This
helps to prevent damage to the vehicle.
Installing/removing
The wind screen protects against wind when
driving with the soft top open. It is secured
between the roll bars.
The wind screen is in wind screen bag : on the
tank partition wall in the trunk.
page 110).
page 80).
Y
Pull over and stop the vehicle safely as soon
X
as possible, paying attention to road and traf-
fic conditions.
Secure the vehicle against rolling away
X
( page 127).
Y
Open the trunk.
X
Detach wind screen bag : from four press-
X
studs ; on the tank partition wall.
Remove the wind screen from wind screen
X
bag :.
Attach wind screen bag : to the tank parti-
X
tion wall again.
To install: fold both fastening levers ? on
X
wind screen = inwards in the direction of the
arrow.
Push wind screen = into the recess between
X
the roll bars up to the locking point.
Fold both fastening levers ? on wind screen
X
= outwards.
To remove: fold both fastening levers ? on
X
wind screen = inwards in the direction of the
arrow.
Pull wind screen = upward.
X
Detach the wind screen bag and remove it
X
from the trunk and stow wind screen = in it.
Attach the wind screen bag to the tank parti-
X
tion wall in the trunk again.