Table of Contents
Advertisement
Flat tire
252
Affix part : of the TIREFIT sticker to the
X
instrument cluster within the driver's field of
vision.
Affix part ; of the TIREFIT sticker near the
X
valve on the wheel with the defective tire.
Tire sealant filler bottle
:
Recess
;
On/off switch
=
Connector
?
A
Hose
Flange
B
Pull connector ? with cable and hose A out
X
of the tire inflation compressor housing.
Push connector on hose A into flange B on
X
tire sealant bottle : until the connector
engages.
Place tire sealant bottle : head down into
X
recess ; of the tire inflation compressor.
Remove the cap from valve C on the faulty
X
tire.
Screw filler hose D onto valve C.
X
Insert connector ? into cigarette lighter
X
socket (
page 222) or into another 12 V
Y
socket in your vehicle (
Switch on the ignition with the Start/Stop
X
button.
or
Turn the SmartKey to position 1 in the igni-
X
tion lock (
page 111).
Y
Press on/off switch = on the tire inflation
X
compressor.
The tire inflation compressor is switched on.
The tire is inflated.
First, tire sealant is pumped into the tire. The
pressure may briefly rise to approximately
500 kPa (5 bar/73 psi).
Do not switch off the tire inflation com-
pressor during this phase.
Let the tire inflation compressor run for a
X
maximum of ten minutes. The tire should then
have attained a pressure of at least 180 kPa
(1.8 bar/26 psi).
If a pressure of 180 kPa (1.8 bar/26 psi) has
been attained after five minutes, see "Tire pres-
sure reached" (
page 253).
Y
If a tire pressure of 180 kPa (1.8 bar/26 psi) has
not been attained after five minutes, see "Tire
pressure not reached" (
If tire sealant has escaped, clean it off affected
areas as quickly as possible. It is preferable to
use clean water.
If your clothes are soiled with tire sealant, have
them cleaned with perchloroethylene at a dry
cleaner as soon as possible.
page 222).
Y
page 253).
Y
Advertisement
Table of Contents
