Table of Contents
Advertisement
Chapter 5. Setting Up the PCI-X Dual Channel Ultra320 SCSI
Adapter (AIX)
This chapter provides hardware and software installation verification, adapter configuration, and problem
determination procedures for the PCI-X Dual Channel Ultra320 SCSI Adapter. If you have problems with
your adapter in the future, use the procedures described in this chapter.
Note: If you are using Linux, see "Verifying the Installation" on page 16. If you have another operating
system installed, refer to your operating system documentation for information regarding installing
the device driver software and configuring your system.
Verifying the Installation
Verify the initial installation by using the following procedures:
v Verifying AIX Software Installation (lslpp)
v Verifying Hardware Installation (lsdev)
Verifying AIX Software Installation
To verify that the device driver for the PCI-X Dual Channel Ultra320 SCSI Adapter is installed, do the
following:
1. If necessary, log in as root user.
2. Type
lslpp -l devices.pci.14106602*
Press Enter.
If the PCI-X Dual Channel Ultra320 SCSI Adapter device software is installed, the following is an example
of the data that displays on your screen:
devices.pci.14106602.diag 5.2.0.11 COMMITTED PCI-X Dual Channel Ultra320 SCSI Adapter Diagnostics
devices.pci.14106602.rte
devices.pci.14106602.ucode 5.2.0.0 COMMITTED PCI-X Dual Channel Ultra320 SCSI Adapter Device Microcode
Note: The fileset number (shown as 5.2.0.11) might be different in your output example.
If no data displays on your screen, the PCI-X Dual Channel Ultra320 SCSI Adapter device driver did not
install. Return to "Installing the Adapter" on page 9. Then continue with "Verifying Hardware Installation."
If you continue to experience problems, it may be necessary to call your system support organization.
Refer to your operating system documentation for instructions.
Verifying Hardware Installation
To verify that your system unit recognizes the PCI-X Dual Channel Ultra320 SCSI Adapter, do the
following:
1. If necessary, log in as root user.
2. Type
lsdev -C | grep scsi
Press Enter.
If the PCI-X Dual Channel Ultra320 SCSI Adapter installed correctly, the following is an example of the
data that displays on your screen:
5.2.0.11 COMMITTED PCI-X Dual Channel Ultra320 SCSI Adapter Device Software
11
Advertisement
Table of Contents
