Table of Contents
Advertisement
USER CONFIGURATION
To set the PAN to inverting or non-inverting
•
Press the MODE button until it shows "Pan Inverse", then press ENTER and the
LCD will show "OFF" or "ON".
Use the UP/DOWN buttons to set the desired inversion and press ENTER to
•
confirm.
To set the Tilt to inverting or non-inverting
•
Press the MODE button until it shows "Tilt Inverse", then press ENTER and the
LCD will show "OFF" or "ON".
•
Use the UP/DOWN buttons to set the desired inversion and press ENTER to
confirm.
To set the DMX channel configuration
•
Press the MODE button until it shows "Channel set", then press ENTER and the
LCD will show "9CH" or "16CH".
•
Use the UP/DOWN buttons to set the desired channel mode and press ENTER to
confirm.
SERVICE FUNCTIONS
To reset the fixture:
•
Press the MODE button until the display shows "FIXTURE REST".
•
Press ENTER to confirm your selection.
To restore all settings to their factory defaults:
•
Press the MODE button until the display reads "DEFAULT CONFIRM".
•
Press ENTER to confirm your selection.
OPERATION MODE
•
Press the MODE button until it reads "Show Mode", then press ENTER and the
LCD will show modes for you to choose.
•
Use the UP/DOWN buttons to set the desired inversion, then press ENTER to
confirm.
Fast Mode/Slow Mode (Auto Mode):
•
This mode allows a single unit to run to a factory installed programme in one of
two speeds:
"1) To set a fixture in Fast Mode, then the light will run in a fast speed running."
"2) To set a fixture in Slow Mode, then the light will run in a fast speed running."
Master/Slave Mode
•
This mode will allow you to link up to 32 units together without a controller.
•
Use standard DMX cables to daisy chain your units together via the DMX
connector on the rear of the units. Proper performance it may be necessary to use
a terminator at the last fixture.
8
Advertisement
Table of Contents
