Servicing Precautions - Pace MBT 201A Operation & Maintenance Manual

Table of Contents

PRECAUTIONS

The following are general safety precautions which personnel must understand and follow when using or

servicing this product. These precautions may or may not be included elsewhere in this manual.

USEAGE PRECAUTIONS

CAUTIONS

1. SensaTemp handpiece heaters and installed tips are hot when handpiece is powered on. DO NOT touch

either the heater or tip. Severe burns may result! Always store handpiece in the appropriate cubby when

not in use.

2. Always use this system in a well ventilated area. A fume extraction system such as those marketed by

PACE are highly recommended to protect personnel from solder flux fumes.

3. Exercise proper precautions when using chemicals (e.g., solder paste). Refer to the Material Safety Data

Sheet (MSDS) supplied with each chemical and adhere to all safety precautions recommended by the

manufacturer.

NOTES

1. The solder collection chamber in the PACE Sodr-X-Tractor is made of glass. Never remove this

chamber using pliers. Breakage of the chamber may result. Always remove using the procedures

recommended by PACE in the associated handpiece manual.

2. The front end (heater end) of the glass solder collection chamber in the PACE Sodr-X-Tractor is hot

when the handpiece is in use. When removing the chamber for cleaning, grip the chamber at the rear

seal. Never touch the front end of the glass chamber with bare hands. Allow the chamber to cool

before cleaning.

3. Always store any connected handpiece in the appropriate Tip & Tool Stand.