Listening To Fm Radio - Panasonic RX-D500 Operating Instructions Manual

Listening to FM radio

You can preset up to 30 FM channels.
Channel 1 to 5 will be set under [1] to [5] on this unit.
(l right, "Changing the stations stored under [1] to [5]")
Preparation
≥ Extend the antenna. (l 4)
≥ Turn the unit on.
≥ Press [FM] to select "FM".
Presetting stations automatically
1
Press [SETUP] to select "A.PRESET".
2
Press [:/6] or [5/9] to select "LOWEST" or
"CURRENT" and then press [1/;].
LOWEST:
To begin auto preset with the lowest frequency
("FM 87.50").
CURRENT:
To begin auto preset with the current frequency.
≥ The tuner starts to preset all the stations it can receive into
the channels in ascending order.
≥ To cancel, press [∫].
§:
To change the frequency, refer to "Manual tuning".
Listening to a preset channel
1
Press [SETUP] repeatedly to select "TUNE MODE".
2
Press [:/6] or [5/9] to select "PRESET"
and then press [1/;].
3
Press [:/6] or [5/9] to select the channel.
≥ You can select channel 1 to 5 by pressing one of [1] to [5] on this
unit.
∫ Manual tuning
1
Press [SETUP] repeatedly to select "TUNE MODE".
2
Press [:/6] or [5/9] to select "MANUAL"
and then press [1/;].
3
Press [:/6] or [5/9] to tune in to the
station.
To tune automatically, press and hold the button until
the frequency starts changing quickly.
Presetting stations manually
1
While listening to the radio broadcast
Press [1/;].
2
Press [:/6] or [5/9] to select the channel
and then press [1/;].
≥ Do steps 1 through 2 again to preset more stations.
≥ A station previously stored is overwritten when another station is
stored in the same channel preset.
Changing the stations stored under [1]
to [5]
You can change the stations stored under [1] to [5] easily.
While listening to the radio broadcast
Press and hold one of [1] to [5] until "P " appears on the
§
display.
(" " stands for a number.)
≥ When you change the stations stored under [1] to [5], channel 1
to 5 are also changed to the same corresponding stations.
∫ To display the current FM signal status
Press [DISPLAY].
"FM ST":
"FM - - - -":
"FM MONO": You have set the "FM MODE" to "MONO".
≥ "STEREO" is displayed when this unit tunes to a stereo
broadcast.
- 7 -
FM stereo broadcast is being received.
No broadcast is received or FM broadcast
received is weak or in monaural.
(l 11, "If noise is excessive during FM
reception.")