Checking The Battery Charge Level; Recharging The Battery; Checking The Function Of The Protective Hood; Installing/Changing The Saw Blade - Parkside PHKSA 12 B3 Translation Of The Original Instructions

Checking the battery charge
level
The battery's ( 4) charge level is indicat-
ed by the charge state indicator (
The LEDs indicate the battery's charge
level, when the device is in operation.
Press and hold the power button (
red-yellow-green => Battery fully charged
red and yellow
=> Battery half charged
red
=> Battery needs

Recharging the battery

Allow a hot battery to cool before
charging.
Charge the battery (
only the red LED on the level indica-
tor is illuminated.
The charging time is around 1 hour
(PLGK 12 B2).
1. Remove the battery (
pliance.
2. Plug the battery charger (
mains outlet.
3. Insert the battery (
ing compartment of the battery charger
( 27).
4. Pull the battery (
tery charger (
5. Unplug the battery charger (
from the mains.
Checking the function of
the protective hood
• Pull the pull lever for the protective
hood ( 23) back as far as it will
18).
2).
to be charged
4) when
4) from the ap-
27) into a
4) in the charg-
4) out of the bat-
27).
27)
go. The protective hood (9) must move
freely without jamming and jump back
to the original position automatically
when the pull lever for the protective
hood (
23) is released.
• Always keep the protective hood
(9) free of sawdust to keep it from
jamming the mechanism.
Installing/changing the
saw blade
Switch off the device and remove
the battery before carrying out any
work.
1. Set the cutting depth to the minimum
position, 0 mm (using the retaining
screw (6) ).
2. Using the pull lever for the protective
hood (23), move the protective hood
back and switch the device off.
3. Press and hold down the spindle lock
(15).
4. Loosen the clamping screw (22) with
the Allen key (24).
5. Now, remove the clamping screw (22)
and the clamping flange (21).
6. Pull the pull lever for the protective
hood (23) all the way back and hold
the protective hood (9) in this position.
7. Carefully remove the saw blade (8)
from the device from below.
8. Install the saw blade (8) in the reverse
order.
WARNING! The arrow on the saw
blade must match the direction ar-
row (direction of travel, marked on
the protective hood).
Make sure that the saw blade is
suitable for the speed of the tool.
GB IE
31