Memory Modules; Removing Memory Module; Installing Memory Module - Dell Latitude 7290 Owner's Manual

NOTE: When installing the wireless and WWAN antennae must be routed correctly into the routing pads/clips on the
system board. For models shipped with a wireless card only, the technicians must always ensure that protective sleeves
are used to isolate the antenna connectors before reassembling the system.
4. Connect the battery cable to the connector on the system board.
5. Install the base cover.
6. Follow the procedure in

Memory modules

Removing memory module

1. Follow the procedure in
2. Remove the base cover.
3. Disconnect the battery cable from the connector on the system board.
4. To remove the memory module:
a. Pull the clips securing the memory module until the module snaps-out [1].
b. Remove the memory module from the connector on the system board [2].

Installing memory module

1. Insert module in connector then press Module down onto clips unit it snaps in.
2. Connect the battery cable to the connector on the system board.
3. Install the base cover.
22 Removing and installing components
After working inside your
Before working inside your
computer.
computer.