Functional Description; Operation - Milwaukee M18 FMTIW2F12 Operator's Manual

FUNCTIONAL DESCRIPTION

1
2
3
4
5
6
1. 1/2" Square drive anvil with pin detent
(M18 FMTIW2P12)
2. LED
3. Control switch
4. Trigger
5. 4-Mode drive control
6. Belt clip
7. 1/2" Square drive anvil with friction ring
(M18 FMTIW2F12)
ASSEMBLY
Recharge
WARNING
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use
WARNING
reco mmended
may be hazardous.
cally designed for use on impact wrenches. Other
sockets and accessories might shatter or break
causing injury.
Attaching and Removing Accessories
1/2" Pin Detent
(Cat. No. M18 FMTIW2P12)
1. Use only the appropriate size Square Drive
Sockets.
2. To attach a socket, align the hole in the accessory
with the detent pin on the anvil. Hold the detent
pin in while pushing the socket onto the anvil.
The detent pin will snap into place in the hole to
secure the socket.
3. To remove the socket, insert a nail or other thin
object into the hole in the accessory and press
7
onl y with th e ch arg
for the battery . For
accessorie s
for thi s tool. Others
1/2" Friction Ring
(Cat. No.M18 FMTIW2F12)
1. Use only the appropriate size Square Drive
Sockets.
2. To attach a socket, align the accessory with the
the anvil.
WARNING
to comply with AS/NZS 1337.1.
When working in dusty situations, wear
appropriate respiratory protection or use a
suitable dust extraction solution.
WARNING
mended for this tool. Others may be hazardous.
Using the Drive Control
The drive control button is used to adjust the torque,
rotation speed (RPM), and impact speed (IPM) for
and IPM).
To select the drive control mode:
1. Pull and release the trigger to turn on the tool. The
current mode indicator is lit.
2. Press the drive control button
the 4 modes. When the desired mode indicator is
lit, begin work.
3. In mode:
•
the tool runs at a re-
duced RPM and then
er
sh uts off onc e t he
spe -
torque is achieved.
• B o l t R e m o v a l - I n
reverse, the tool runs at
full RPM and IPM until
the nut breaks free from the joint. Then, the tool
slows to a reduced RPM for better control in
removing the nut.
Mode
Indicators
-
4

OPERATION

To reduce the risk of injury, always
wear proper eye protection marked
Always remove battery pack before
changing or removing accesso-
Mode
- In forward,
1
2
3
-
to cycle through
RPM IPM
0-1250 0-900
0-1950 0-2100
0-2575 0-3100
0-2575 0-3100
Drive
Control
Button