Table of Contents
Advertisement
Front button
The front button is located above the three-position button.
The button is user-defined and can be controlled via wiring.
Attention!
This signal is not failsafe and shall never be used for a safety function.
Note on activation of front button
The button must be pressed down vertically. If the angle exceeds 15° when actuating the switch, the switch
contact may be damaged, reducing it lifetime (number of switching cycles).
Top buttons
The two top buttons are located at the top part of the HD5.
The buttons are user-defined and can be controlled via wiring.
Button 1 is marked +
Button 2 is marked –
Attention!
This signal is not failsafe and shall never be used for a safety function.
Signal LED
A green and a red LED are integrated in the housing, above the emergency
stop button. The LEDs are user-defined and can be controlled in via wiring.
2TLC010052M0201_A
13
2
1
Advertisement
Table of Contents
