ViewSonic LS920WU User Manual page 57

Menu Option
HDR
3X Fast Input
LAN Control Settings
Description
HDR/HLG
The projector supports HDR imaging sources. It can
automatically detect the dynamic range of the source, and
optimize image gamma and color settings to reproduce
contents under wide range of light conditions. You also select
SDR.
EOTF
The projector can automatically adjust the brightness levels
of your image according to the input source. Normally, the
default setting "Mid" is recommended. If the brightness of the
projected image is dark, please use "Low". When giving priority
to gradation property, please use "High".
This function is favorable to frame rate reducing. Quick
response time in native timing can be achieved. When enabled,
the following settings will return to factory preset values:
Aspect Ratio, Position, Zoom, OverScan.
NOTE:
This function is only available when a native timing input
signal is selected.
LAN Settings
ͫ DHCP ON: Select this if you are in a DHCP environment
and Projector IP Address,
DNS Server settings will be automatically retrieved.
ͫ Static IP: Select this if you are in a non-DHCP environment
and make adjustments to below settings.
Projector IP Address
Subnet Mask
Default Gateway
DNS Server
Standby LAN Control
Allows the projector to provide the network function in
standby mode.
Apply
Enacts the settings.
Subnet Mask, Default Gateway,
Only available when LAN Settings is
set to Static IP. Use
column and use
value.
57
/ to select a
/ to adjust the