Appendix B: Programming Remote Control Codes; Learning Remote Codes - Sony NHS-2000 Installation Manual

Appendix B: Programming Remote Control Codes
IMPORTANT NOTICE REGARDING SET-TOP BOXES. The system's Multi-Room Distribution Unit is shipped from Sony pre-
programmed for the remote control codes of the supplied Sony A/V components. However, if your customer wants remote control
capability for a centrally-mounted cable, satellite or HDTV set-top box, you must program these additional remote control codes into the
Multi-Room Distribution Unit. Sony has provided "slots" that are waiting for the remote codes of the specific cable, satellite or HDTV
set-top box. Filling up those slots is a relatively quick process, using the following procedure and the Multi-Room Distribution Unit's
SETUP mode.
IMPORTANT NOTICE: Further information on the Multi-Room Distribution Unit can be found at on the Internet at
www.sony.com/m1000.

Learning remote codes

1. On the Multi-Room Distribution Unit, press MODE repeatedly until "<<LEARN>>
ENTER. "WHICH MENU?" appears for a few seconds.
2. Press the cursor or cursor repeatedly to select "CODE LEARNING", then press ENTER. "CONNECT TO?" appears for a few
seconds.
3. Press the cursor or cursor repeatedly to select the desired component. Each time you press the cursor or cursor, the display
window changes cyclically as shown below. CONNECT TO? (Appears for a few seconds)
SOURCE 1
SOURCE 8
COMMON 1
←
COMMON 10
NOTE: SOURCE or COMMON components, which have been set to learn command codes on PC SETUP, appear with an exclamation
mark (!) at the left side of the display window.
4. Press ENTER. "INPUT IR CODE" appears for a few seconds, then display window changes to "CODE ID #001
NOTE: Refer to "PRESET and LEARN Mode Code List" below to see the code ID number corresponding to each IR command. For
example, if "CODE ID #001" is displayed, press Num1 of the remote control of the source component to learn it into the Multi-Room
Distribution Unit.
5. While the code ID number is displayed in the display window, press the corresponding button on the remote control of the
component while pointing it toward the learning IR window of the Multi-Room Distribution Unit. Make sure the distance between the
remote control and the IR window is within 10 cm. When your entries are confirmed, "COMPLETED!" appears for a few seconds,
then the display window moves to the next remote code entry. If your entries are not confirmed, "LEARN FAILED!" appears for a few
seconds, then the failed code ID number appears.
30
←
" appears in the display window, then press
"