Remote Room: Keypads - Sony NHS-2000 Installation Manual

Pre-wiring

Remote Room: Keypads

The number of in-wall keypads you will need to install depends on the specific system.
Please refer to the chart below for details.
System
Number of rooms
Number of zones
Remote rooms with audio and video from main system
In-wall remote controls
Remote room handheld infrared remote controls
1. Confirm the locations of all in-wall remote controls on the wire plan.
2. Install 2-gang junction boxes, 36 cubic inches or larger in every remote room for the in-wall remote
controls and in-wall volume controls.
3. Run two cables from each junction box to the System Rack location:
A. One 14-gauge, 4-conductor (14-4) speaker cable.
B. One Cat 5 remote control cable.
4. Label all cables on both ends.
10
NHS-2000
3 (Main + 2 remote);
expandable to 7 (Main + 6 remote)
3 (expandable to 7)
2 (expandable to 6)
2 (expandable to 6)
2 (expandable to 6)
NHS-1000
3 (Main + 2 remote);
expandable to 7 (Main + 6 remote)
3 (expandable to 7)
2 (expandable to 6)
2 (expandable to 6)
2 (expandable to 6)