Troubleshooting - Dyna-Glo DGP552SSP Manual

TROUBLESHOOTING

8:00 a.m. – 4:30 p.m., CST, Monday – Friday.
PROBLEM
The burner will not
light using the
ignitor procedure
(weak or no spark
Low Heat.
Excessive
Flare Ups.
POSSIBLE CAUSE
1. The igniter electrode may be
covered with grease or residue.
2. The igniter electrode may
have a loose or disconnected
wire.
3. Cracked or broken ignition
electrode.
the unit.
1. Grease and/or residue
build-up on heat tents or in
2. Excessive dripping of fat or
marinade from food.
3. Cooking temperature too high.
CORRECTIVE ACTION
1. Clean the ignitor electrode.
2. Check the connection and reconnect any
loose or disconnected wires.
3. Replace ignition electrode
(see Replacement Parts List).
the gas supply pressure and correct the
pressure.
1. Clean the grill components.
2. Trim the fat from meat and use non-oil
based marinades.
3. Lower temperature accordingly.
26
1-877-447-4768,