Onboard Floppy Disk Controller ......[Disabled]
Onboard IDE Primary Channel .........[Enabled ]
Onboard PS/2 Mouse (IRQ 12) .........[Enabled ]
Onboard USB .........................[Disabled]
USB Legacy Mode ..................[--------]
Onboard SCSI1 .......................[Disabled]
Boot from SCSI1 Device ............[Enabled ]
Onboard SCSI2 .......................[Enabled ]
Boot from SCSI2 Device ............[Enabled ]
Onboard Ethernet Chip ...............[Disabled]
= Move Highlight Bar,
PgDn/PgUp = Move Screen
Serial Port 1
This parameter allows you to enable or disable the serial port 1. The
Base Address and IRQ items are configurable only if this parameter is
enabled.
This function lets you set a logical base address for serial port 1. The
options are:
3F8h
This function lets you assign an interrupt for serial port 1. The options
are IRQ
and
.
3
4
BIOS Utility
Onboard Devices Configuration
= Change Setting, F1 = Help
Base Address
2F8h
IRQ
Page 2/2
3E8h
2E8h
3-23