Wolf WF-300 Operation And Maintenance Instructions

Wolf Safety Lamp Company
Wolf WF-300 LED Floodlite
Operation and Maintenance Instructions
Please Retain – Read Before Use
EC Declaration of Conformity
The Wolf WF-300 LED Floodlite meets all relevant
provisions of the 94/9/EC (ATEX Equipment) Directive
by virtue of the issued EC Type Examination
Certificate, demonstrating compliance with all relevant
Harmonised Standards and Essential Health and
Safety Requirements.
The Wolf WF-300 LED Floodlite is a high performance
lightweight portable floodlight. Constructed in marine
grade aluminium, with a polycarbonate lens: the end
user must check that these materials are suitable for
the atmosphere the Floodlite will be used in. The
Floodlite can be used in Zone 1 and Zone 2 potentially
explosive gas, vapour, mist and dust atmospheres
where the surface temperature / temperature class
and gas group permit.
The incoming mains cable should not exceed a
temperature rise of 61
conditions; select suitable cable and cable gland.
II 2GD Ex emb IIC T4 Gb (Ta = -20
o
Ex t IIIC T103 C Db IP66 & IP67
EC Type Examination Certificate:
Notified Baseefa Ltd.
Body: Rockhead Business Park, Staden
Lane, Buxton, SK17 9RZ, UK
Notified body number: 1180
Harmonised standards applied:
EN60079-0:2006, EN60079-7:2007,
EN60079-18:2009, EN61241-0:2006,
EN61241-1:2004, IEC60079-0:2007.
Wolf LED Floodlites are certified compliant with the
2004/108/EC EMC Directive.
The product is CE marked showing compliance with all
relevant EC Directives
Alex Jackson – Technical Director
Wolf Safety Lamp Company Ltd
WWW.CABLEJOINTS.CO.UK
THORNE & DERRICK UK
TEL 0044 191 490 1547 FAX 0044 477 5371
TEL 0044 117 977 4647 FAX 0044 977 5582
WWW.THORNEANDDERRICK.CO.UK
o
C above the ambient
o o
C to +50 C)
IMPORTANT
Read these instructions carefully before commencing
to use the Floodlite and retain for future use.

Check the rating label to ensure the Floodlite is
suitable for the
temperature present and IP rating.

ATEX certification includes assessment of product
safety at ±10% of rated voltage, running lamps
outside of this voltage tolerance will therefore
invalidate the ATEX approval and the product
warranty, may result in a dangerous condition, and
could cause the product to fail prematurely.

If the Floodlite is to be used in areas of high
vibration, please consult with Wolf Safety.

ELECTROSTATIC CHARGING HAZARD Clean
lens with damp cloth.

The Floodlite consists of an Ex mb LED chamber
and an Ex emb terminal chamber.

All Floodlites have terminal blocks suitable for up
2
to 4mm live, neutral and earth.

ATEX approved cable glands must be used and
be suitable for the type of cable used. Any unused
cable entries should be blanked off with a suitable
ATEX approved stopper plug to maintain a
minimum IP66/67 rating as marked on the label.
Special conditions for safe use (denoted by X
after the certificate number)

Always use the lamp in the bridle provided.

Except for internal wiring, not more than one
single or multiple strand lead shall be
connected into either side of any terminal,
unless multiple conductors have been joined
in a suitable manner, e.g. two conductors into
a single insulated crimped boot lace ferrule.

Leads connected to the terminals shall be
insulated for the appropriate voltage and this
insulation shall extend to within 1 mm of the
metal of the terminal throat.

When terminals in accordance with certificate
IECEx SIR 05.0035U are used, all terminal
screws, used and unused, shall be tightened
down to between 0.5 Nm and 0.7 Nm.

When terminals in accordance with certificate
IECEx SIR 05.0037U are used, all terminal
screws, used and unused, shall be tightened
down to between 1.2 Nm and 2 Nm.
supply provided, ambient