Wolf Safety Lamp Company
Saxon Road Works, Sheffield S8 0YA, England
Tel: +44 114 255 1051 Fax: +44 114 255 7988
Wolf WF-300 LED Floodlite
Operation and Maintenance Instructions
Please Retain – Read Before Use
EC Declaration of Conformity
The Wolf WF-300 LED Floodlite meets all relevant
provisions of the 94/9/EC (ATEX Equipment) Directive
by virtue of the issued EC Type Examination
Certificate, demonstrating compliance with all relevant
Harmonised Standards and Essential Health and
Safety Requirements.
The Wolf WF-300 LED Floodlite is a high performance
lightweight portable floodlight. Constructed in marine
grade aluminium, with a polycarbonate lens: the end
user must check that these materials are suitable for
the atmosphere the Floodlite will be used in. The
Floodlite can be used in Zone 1 and Zone 2 potentially
explosive gas, vapour, mist and dust atmospheres
where the surface temperature / temperature class
and gas group permit.
The incoming mains cable should not exceed a
temperature
rise
of
conditions; select suitable cable and cable gland.
II 2GD Ex emb IIC T4 Gb (Ta = -20
o
Ex t IIIC T103
C Db IP66 & IP67
EC Type Examination Certificate:
Notified
Baseefa Ltd.
Body:
Rockhead Business Park, Staden
Lane, Buxton, SK17 9RZ, UK
Notified body number: 1180
Harmonised standards applied:
EN60079-0:2009, EN60079-7:2007,
IEC60079-18:2009, IEC60079-31:2008,
Wolf LED Floodlites are certified compliant with the
2008/108/EC EMC Directive.
The product is CE marked showing compliance with all
relevant EC Directives
Alex Jackson – Technical Director
Wolf Safety Lamp Company Ltd
o
61
C
above
the
ambient
o
o
C to +50
IMPORTANT
Read these instructions carefully before commencing
to use the Floodlite and retain for future use.
•
Check the rating label to ensure the Floodlite is
suitable
temperature present and IP rating.
•
ATEX certification includes assessment of product
safety at ±10% of rated voltage, running lamps
outside of this voltage tolerance will therefore
invalidate the ATEX approval and the product
warranty, may result in a dangerous condition, and
could cause the product to fail prematurely.
•
If the Floodlite is to be used in areas of high
vibration, please consult with Wolf Safety.
•
ELECTROSTATIC CHARGING HAZARD Clean
lens with damp cloth.
•
The Floodlite consists of an Ex mb LED chamber
and an Ex emb terminal chamber.
•
All Floodlites have terminal blocks suitable for up
to 4mm
•
ATEX approved cable glands must be used and
be suitable for the type of cable used. Any unused
cable entries should be blanked off with a suitable
ATEX approved stopper plug to maintain a
minimum IP66/67 rating as marked on the label.
•
This product is Class1 equipment and must be
earthed. Floodlites are supplied as standard with 3
core earthed supply cables. Where the user
specifically requires a 24 volt SELV Floodlite with
C)
2 core cable (+ve and -ve) / a 2 pole plug, the
Floodlite must be used with a separate connection
to earth via the external earth grounding point.
•
The Floodlite lens is moulded in Polycarbonate,
the end user must ensure that this is suitable for
the atmosphere the Floodlite will be used in.
•
Do not connect 24 volt lamps to a centre
tapped earth transformer (CTE), permanent
damage to the product is likely to occur.
When user is ≤ 0.35m from the WF-300:
Risk Group 2.
Caution: possible hazardous optical radiation
emitted from this product DO NOT stare at the
operating lamp. May be harmful to the eye.
Special conditions for safe use (denoted by X
after the certificate number)
•
Always use the lamp in the bridle provided.
•
Except for internal wiring, not more than one
single or multiple strand lead shall be
connected into either side of any terminal,
unless multiple conductors have been joined
in a suitable manner, e.g. two conductors into
a single insulated crimped boot lace ferrule.
for
the
supply
provided,
2
live, neutral and earth.
ambient