D-Link DWR-956M User Manual page 38

Interface: ETH
Mode: PPPoE
Connection Name: Assign a name for the connection here.
Enable: Tick this to enable this connection.
MTU: The Maximum Transmission Unit (MTU) of the WAN
connection. This is set to 1492 bytes by default.
IP Protocol Type: The IP protocol version used by the WAN connection.
This can be IPv4, IPv6 or IPv4&6. Choosing one of these options displays
other options on the page, and each of these is documented below.
NAT: Enable or disable Network Address Translation (NAT) on the WAN connection.
Tick this to enable NAT.
Firewall: Whether to enable or disable packet filtering. Tick this to enable packet filtering.
This feature is ticket by default
IPv4 Static DNS: Whether to enable or disable static DNS entries. Tick this to enter static DNS
entries, or un-tick it assign the DNS servers using DHCP.
Ticking the box displays other options on the page, and these are documented below.
PPPoE Type: The PPPoE type for the WAN connection.
This can be Normal PPPoE or PPPoE Proxy.
Choosing the PPPoE Proxy option displays other options on the page,
and each of these is documented below.
Servicename: The name of the PPPoE service on the router. This is used for reference only.
User Name: The username used to connect to the PPPoE session.
This should be supplied to you by your ISP.
Password: The password used to connect to the PPPoE session.
This should be supplied to you by your ISP.