Advertisement
Usual phenomena and handIings
No.:
Phenomena
The heating tube
component does
not work.
1
The heating tube
component is
working.
The heating tube
component does
2
not work.
'C1" or "C2" shows on
the control panel and
3
the buzzer keeps
sounding.
Dirt floats in the water
4
or water with bad smell.
The steamer is still
working when there
5
is no water inside.
The steamer does
6
not work after dry
heat protection.
Technical parameters
Model No.: GFS136
Voltage: 220-240V~
Product dimension(mm): 335×300×411mm (with 2 tiers and lid)
Causes
1. The power source is not
connected.
2. The power circuit is
damaged.
The control panel is
damaged.
1. The heating tube
component is burnt out.
2. Connection of the circuit
panel is disconnected.
Sensor open or short
circuit.
Not being clean completely.
Sensor failure.
The heating pipe component
is not completely cooled and
the dry-burning thermostat is
not reset.
Frequency: 50Hz
Power: 1360W
9
Handlings
1. Check to see if the plug
(whether connected properly),
the socket, the fuse and the
power cable are all ok.
2. Contact our after sales
service centre for assistance.
Contact our after sales
service centre for assistance.
Contact our after sales
service centre for assistance.
Contact our after sales
service centre for assistance.
Stop working and wash the
steamer throughlly.
Contact our aftersales
service centre for assistance.
Add cold water to the steamer
over the lower water level to
reduce the heat pipe
temperature.
Steamer/Cook pot capacity: 3L
Total capacity of 2 steam tiers: 11L
Advertisement
