Verification Test
Examples
Using an
Agilent E1445A as
the Commander
Agilent E1405/E1406 Commander
INPut[1]
:ATTenuation
:IMPedance
INPut2
:ATTenuation
:IMPedance
OUTPut1
:ATTenuation
:IMPedance
:OVERload?
[:STATe]
:ACTual?
OUTPut2
:IMPedance
OUTPut3
:IMPedance
SOURce:VOLTage
[:LEVel][:IMMediate]:OFFSet
2-2 Verification Tests
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Each verification test procedure includes an example program that
performs the test. All example programs assume the following
configuration:
•
Controller is an HP 9000 Series 200/300 computer
•
Programming language is BASIC
•
Amplifier address is 70911 (logical address is 88)
•
Amplifier Commander is an Agilent E1405/E1406
•
DMM is an Agilent 3458A at address 722
The procedures and examples in this chapter assume that the amplifier
is configured as a stand-alone instrument. (i.e., it is not a servant of an
Agilent E1445A Arbitrary Function Generator). To use an Agilent
E1445A as the commander, make sure that the amplifier is placed in the
servant area of the E1445A, then send all commmands to the E1445A
address (see the Agilent E1446A User's Manual for more information).
The procedures and examples in this chapter can be modified to work
with an E1445A as the Commander by changing the following keywords
as shown and sending all commands to the E1445A.
Agilent E1446A Commands
INPut[1]
:ATTenuation
:IMPedance
INPut2
:ATTenuation
:IMPedance
OUTPut2
:ATTenuation
:IMPedance
:OVERload?
[:STATe]
:ACTual?
OUTPut3
:IMPedance
OUTPut4
:IMPedance
SOURce2:VOLTage
[:LEVel][:IMMediate]:OFFSet
Agilent E1445A Commander