Cordless accessory speakerphone for use with many at&t business phones and at&t cl, crl, clp, tl and vtech ds, sn, is series home cordless phones (55 pages)
Getting started Handset layout IN USE Flashes quickly when there is an incoming call. Flashes slowly when the telephone line cord is not plugged into a wall jack or another telephone at the same line is in use. OPTION Press to display the setting options.
Getting started Screen display messages 10 : 03 12/01 CALL# 800-222-3111 TOTAL 12 NEW 01 Screen icons CALL# Call number in the call log. New (unreviewed) call. Repeat call from the same number. • The telephone line cord is not plugged into a wall jack. •...
Getting started Battery installation Before using the telephone, you should install four good AA alkaline batteries (not included) to provide memory backup and enable the use of some features. The four AA batteries are required for caller ID features and the IN USE light to work.
Getting started Telephone installation If you subscribe to high-speed Internet service (digital subscriber line - DSL) through your telephone lines, you must install a DSL filter between the telephone line cord and the telephone wall jack. The filter prevents noise and caller ID problems caused by DSL interference.
Getting started Installation options Your telephone base is ready for tabletop use. If you want to mount your telephone on a wall, use the provided wall mount bracket to connect with a standard dual-stud telephone wall mounting plate. If you do not have this mounting plate, you can purchase one from many hardware or consumer electronic retailers.
Page 7
Getting started Installation options 4. Route the telephone line cord through the slot as shown below and plug the other end of the telephone line cord into a telephone wall jack. To mount the telephone on the wall, position the mounting holes A and B over the telephone outlet mounting studs.
Page 8
Getting started Installation options 3. Remove the bracket from the base, hold the telephone base firmly, slide the bracket downwards as the arrows indicate. 5. Route the telephone line cord through the slot as shown below. Plug the other end of the telephone line cord into the telephone wall jack.