How To Maintain Your Vacuum Cleaner; Dust Cup; Washable Brushroll - Eureka NER700 Series Owner's Manual

charging contacts and sensors on front bumper to ensure they are not blocked.
!
Never operate vacuum
in proper position.
Moving parts!
Recharge cleaner after
each use.
Make sure vacuum cleaner is turned off and not plugged into a power source.
Do not attempt to remove belt. Call the Eureka Customer Service HELPLINE at 1-800-282-2886.
1. Pull middle area of brush roll bottom cover to disassemble it.
2. Brush roll can then be lifted out by pulling up on the right side.
Any threads, hair or debris can be cut away with scissors or
using the included brush cleaner. Be sure to remove any hair
or strings which may have wrapped around the tips of the
brush roll.
If spinning brush is curled, you can remove it and place in
warm water for 30 seconds and then let it thoroughly dry. Also
regularly use the brush cleaner to remove dust, debris and hair
from the spinning brush. Brushroll frame can also be removed and
cleaned but lifting out. When putting back in ensure the side with
Every time when you empty your dust cup, please clean your filter
at same time.
10
Eureka Customer Service HELPLINE 1-800-282-2886
Regularly use a dry cloth to remove dust and debris from cliff sensors,
1. Press dust cup release button to
remove dust cup from robot.
2. Open dust cup top lid and drop out dust.
3. HEPA filter is on the side of dust cup.
4. Have dust cup insert back to robot.
!