Equipment Preparation - APW Wyott HML2-10 Installation And Operating Instructions Manual

Plate dispensers, drop-in adjustube ii / drop-in lowerator / trendline mobile adjustube ii / trendline mobile dish dispenser / mobile adjustube ii / mobile lowerator

Hide thumbs

Table of Contents

Clean the unit before using. Wipe body and the inside of the unit with a hot, wet cloth to remove any shipping

dust or protective oil.

INSTRUCTIONS:

6-1/2" TO 9-3/4" China:

Align outermost hole in tube head with the storage hole as shown in Figure 1 below. Insert rods into

desired setting and securely screw down rod stops.

10-3/4" China:

Rotate tube head to position shown in Figure 2. Insert rods through unit so they pass inside the black

head weldment below and outside the offset ring weldment to which the springs are attached.

Securely screw down rod stops. This will allow for greater stability and improved rod alignment at

the 10-3/4" china size.

ITEM NUMBER

All other components are the same as the L-9 or HL-9 and the L-12 or HL-12