APW Wyott HML2-10 Installation And Operating Instructions Manual
Plate dispensers, drop-in adjustube ii / drop-in lowerator / trendline mobile adjustube ii / trendline mobile dish dispenser / mobile adjustube ii / mobile lowerator
Page 1
This equipment has been engineered to provide you with year-round dependable service when used according to the instructions in this manual and standard commercial kitchen practices. INSTALLATION OPERATING INSTRUCTIONS Drop-In Adjustube II Drop-In Lowerator Mobile Adjustube II Mobile Lowerator Serial Number Date Purchased APW WYOTT P.O. Box 1829...
APW Wyott takes pride in the design and quality of our products. When used as intended and with proper care and maintenance, you will experience years of reliable operation from this equipment. To ensure best results, it is important that you read and follow the instructions in this manual carefully.
Page 3
IMMEDIATELY INSPECT FOR SHIPPING DAMAGE All containers should be examined for damage before and during unloading. The freight carrier has assumed responsibility for its safe transit and delivery. If equipment is received damaged, either apparent or concealed, a claim must be made with the delivering carrier. A) Apparent damage or loss must be noted on the freight bill at the time of delivery.
A current listing of all authorized APW WYOTT authorized parts/service distributors is included with this product manual at the time of shipment. In the absence of this list you can call the APW WYOTT 24 hour Service Hot Line which gives access to the nearest Authorized APW WYOTT parts/service distributor. Call 1-800-733-2203.
INSTALLATION: Wire the electrical cord into a junction box rated for 110 volts or 220 volts, depending on the electrical specifications of your unit. see the electrical plate on the shield for specifications. Do not attempt electrical hookup unless you have the proper tools and are qualified to do so. SPRING ADJUSTMENT: Adjustubes are factory set to an average rate.
Clean the unit before using. Wipe body and the inside of the unit with a hot, wet cloth to remove any shipping dust or protective oil. ADJUSTING FOR VARIABLE CHINA SIZES INSTRUCTIONS: 6-1/2” TO 9-3/4” China: Align outermost hole in tube head with the storage hole as shown in Figure 1 below. Insert rods into desired setting and securely screw down rod stops.
Page 8
MODEL NUMBER TUBE DIAMETER S/S Head PARTS LIST & EXPLODED VIEW Head Weldment Guide Post Spring, 4 oz. or 2 ½ oz. Offset Ring Weldment...