Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Candy WashPass
Summary of Contents for Candy WashPass
- Page 2 Thank you for choosing this product. WEEE contains both polluting substances (which We are proud to offer the ideal product for can cause negative consequences for the you and the best complete range of home environment) and basic components (which can appliances for your daily routine.
- Page 3 1. GENERAL SAFETY in a safe way and understand the hazards involved. RULES Children shall not play with the This appliance is intended to l appliance. Cleaning and user be used in household and maintenance shall not be made similar applications such as: by children without supervision.
- Page 4 Do not expose the washing l Electrical connections machine to rain, direct sunlight safety instructions or other weather elements. Protect from possible freezing. The technical details (supply l voltage and power input) are When moving, do not lift the indicated on the product rating l...
- Page 5 2. INSTALLATION Remove the 2 or 4 transportation l screws (A) on the back and remove the 2 or 4 flat washers, rubber bungs and plastic spacer tubes (B) as illustrated in figure 1. If the washing machine is built-in, l...
- Page 6 Hydraulic connections l Connect the water hose to the water supply tap (fig. 3) only using the hose supplied with the appliance (do reuse old hose-sets). l SOME MODELS may include one or more of the following features: l HOT&COLD (fig. 4): water mains connection settings with hot and cold water for higher energy savings.
- Page 7 Setting l The washing machine should be installed in its final position such that the water fill hose is not kinked or trapped. The corrugated drain hose should be inserted into suitable drain pipe of between 50 cm and 85 cm height above the floor using the curved drain hose support.
- Page 8 reduce the necessity of a hot wash 3. PRACTICAL HINTS programme. Save energy by using a low temperature wash programme. Load tips Before using drying programme When sorting laundry, make sure: (WASHER-DRYERS) - have eliminated metallic objects such as hair clips, pins, coins, from laundry; l...
- Page 9 l 4. CLEANING AND Repeat the previous steps in reverse order to reassemble all parts. MAINTENANCE To clean the washing machine exterior, use a damp cloth, avoiding abrasives, alcohol and/or solvents. To maintain a good wash performance we recommend that the soap drawer and pump filters are regularly cleaned.
- Page 10 : the door will lock and the controls on the control panel will be disabled. In order to enable the use of the appliance, also by means of the knob, it l Start the cycle using the Candy simply-Fi necessary complete app. When cycle...
- Page 11 6. QUICK USER GUIDE 7. CONTROLS AND PROGRAMS This appliance automatically adjusts the level of the water to the type and quantity of washing. This system gives a reduction in energy consumption and a saving in 90° ° 1000 washing times. 60°...
- Page 12 The default setting for the water WARNING: hardness is set in the factory at level 2 Don’t touch the buttons while inserting (L2) as this satisfies the requirements plug because machines of the majority of users. calibrates the systems during the first seconds: touching the buttons, the Water Hardness level: machine couldn’t work property.
- Page 13 l PAUSING THE MACHINE To start the selected cycle with the preset parameters, press PLAY/PAUSE. When l Keep the PLAY/PAUSE button pressed the programme is running, the display will for about 2 seconds (some light indicators show the time to elapse. and the residual time display will flash, l...
- Page 14 - Confirm by pressing the PLAY/PAUSE - HYGIENE + button. The delay countdown will begin Activated when 60°C and when it has finished the programme temperature. This option allows deep will start automatically. cleaning of your clothes by maintaining the same temperature for the whole wash.
- Page 15 l and refreshed by removing bad smells. If you want carry out a cold wash all the Every program provides a dedicated steam indicators must be off. treatment in order to ensure the maximum cleaning efficiency according to the items SPIN SELECTION button fabric type and colour.
- Page 16 3) DOOR LOCKED INDICATOR LIGHT 5) KEY LOCK INDICATOR LIGHT l The indicator light show that the keys are The indicator light is illuminated when the locked. door is fully closed. Close the door BEFORE selecting the 6) OPTIONS INDICATOR LIGHTS PLAY/PAUSE button.
- Page 17 10) LOW LEVEL WARNING INDICATOR WARNING: LIGHT It turns on when at least one of the tanks To ensure the best performance, the has an estimated value below 20% of the system block the start of a cycle when full volume. The low-level tanks will be one or more tanks are run out.
- Page 18 Table of programmes (MAX.) PROGRAMME (see control panel) (MAX.) DAILY 39' 40° MIXED & 40° COLOURED 59' PERFECT 40° COTTON 59' HYGIENE PLUS 59' 60° SPORT PLUS 29' 30° DELICATE 59' 40° 30° SAVING 30° 40° RINSE DRAIN & SPIN WOOL/HAND WASH 30°...
- Page 19 Please read these notes: ** STANDARD COTTON PROGRAMMES * Maximum load capacity of dry clothes, ACCORDING TO (EU) No 1015/2010 and according to the model used (see control No 1061/2010. panel). COTTON PROGRAMME WITH Only with PREWASH option TEMPERATURE OF 60°C. selected (programmes with...
- Page 20 SPORT PLUS 29' Description of programmes Created to remove dirt from technical garments used in the gym and for sports. To clean different types of fabrics and The programme washes for 29 minutes at a various levels of dirt, the washing machine low temperature.
- Page 21 SYNTHETIC AND COLOURED cleaning results even at only 20°C with This programme allows you to wash normal soiled items. The accurate spin different type’s fabrics and different colours action, ensures a reduced formation of all together. The rotation movement of the creases in the fabrics.
- Page 22 8. TROUBLESHOOTING AND WARRANTY If you believe the washing machine is not working correctly, consult the quick guide provided below which includes some practical tips on how to fix the most common problems. ERROR CODE FORMAT l Models with a display: the error is shown by a number preceded by the letter “E” (example: E2 = Error 2).
- Page 23 OTHER ANOMALIES Problem Possible causes and practical solutions Make sure the product is plugged into a working supply socket. The washing machine Make sure power is on. does not work / start Make sure the wall socket is working, testing it with another appliance such as a lamp.
- Page 24 It is always recommended to use original By placing the mark on this spare parts, that are available at our product, we are confirming compliance Authorised Customer Service Centres. to all relevant European safety, health and environmental requirements which are applicable in legislation for this Warranty product.
- Page 25 fk hldsk...
- Page 26 fk hldsk...
- Page 27 fk hldsk...
- Page 28 - RO Z -...