GE JSP40 Use And Care Manual page 33

How to Set Oven for Cleaning
Easy Steps:
1. Press SELF CLEAN.
2. Press the INCREASE or DECREASE pad to
set the clean time.
3. Press START.
1. Follow the steps in the Before a
Clean Cycle section.
2. Press SELF CLEAN.
SELF
CLEAN
3. Press the INCREASE or
DECREASE pad to set the
clean time, if a time other than
4 hours is needed.
Clean time is normally 4 hours.
You can change the clean time to
any time between 3 to 5 hours,
depending on the amount of soil
in your oven.
To Stop a Clean Cycle
1. Press CLEAR/OFF.
CLEAR
OFF
4. Press START.
START
The door locks automatically. The
display will show the clean time
remaining. It will not be possible to
open the oven door until the temperature
drops below the lock temperature and
the LOCKED DOOR light goes off.
5. When the LOCKED DOOR light is off,
open the door.
NOTE:
• You can find out when the clean cycle
START
will start by pressing START TIME.
TIME
• The display will flash and the control will
beep if you set the clean cycle and forget
to close the oven door.
2. When the oven has cooled below the locking
temperature and the LOCKED DOOR light goes
off, open the door.
(continued next page)
33