Setting Ethernet Ip Parameters - ADTRAN Total Access 544R System Manual

DLP-4 Setting Ethernet IP Parameters
Introduction
If the unit is connected to an IP network for Telnet, TFTP, or SNMP management, several IP parameters
must be set for the unit to communicate with the network. These parameters are described in this DLP
along with the procedures for setting them.
Please see your Network Administrator for the proper assignment of the following
parameters:
Prerequisite Procedures
This procedure assumes that the unit is connected to an IP network and is powered up.
Tools and Materials Required
• VT100 compatible terminal or computer with terminal emulation software
• Appropriate cable to connect terminal to the unit (customer-provided)
• DB-9 female to RJ-45 female adapter for connecting to the
adapter is ADTRAN-proprietary and is provided with the unit.
• Ethernet cable from the
• Use Ethernet crossover if going from the unit to a PC (customer-provided).
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
61200704L2-1B
IP A , S M
DDRESS UBNET
port on the unit to a hub (customer-provided)
10/100B T
ASE
© 2003 ADTRAN, Inc.
and
, D G
ASK EFAULT ATEWAY
port on the rear of the unit. This
CRAFT
.
109