Plb Holster; Figure 7 Gps Interface Without Holster - ACR Electronics TerraFix 406 Product Support Manual

Personal locator beacon
Table of Contents

Advertisement

GPS Interface with holster
4.7.3 GPS I (Interface) connection
The TerraFix™ 406 GPS PLB (P/N 2798.2 and 2798.4) comes standard with a GPS interface cable
with serial port adapter. Connect the serial port adapter to your external GPS connection data cable.
If the holster is on the PLB, align the two tabs on the bottom of the interface with the holes in on the
holster directly above the interface port (see figure 6). Push down and turn to secure the interface
cable to the holster. If the holster in not on the PLB simply hold the interface head on top of the
interface port with your finger (see figure 7).
SECTION 5 – PLB Holster
5.1
The TerraFix™ comes standard with a protective holster that will help protect your PLB from
damage. To install the holster, deploy the external antenna and slide antenna through the open hole
located on the left side of the holster. Slide the holster to the base of the PLB so that the open
antenna hole is flush with the side of the PLB. Close the back of the holster around the back of the
PLB and clip into the front of the holster. Once secured, wrap the external antenna around the base
of the holster and clip into antenna slot on the top right side of the holster (See figure 8).
Note: Use extreme caution; do not apply the holster over the external antenna. In an emergency it is
critical that you deploy the antenna. If the holster is covering the antenna you will not be able to
deploy properly.
5.2
The TerraFix™ holster has been designed to accommodate your extreme adventures. You can secure
your PLB directly to backpack webbing straps or belts to ensure the PLB is close at hand. Ensure the
PLB is secured firmly and is protected before heading out to avoid damage or loss. ACR recommends
that you secure your PLB someplace that is easily accessible in case of an emergency for rapid
activation.
Note: Use care when attaching items to your PLB. Clipping attachments, carabineers, rope,
webbing, etc. will all add weigh and can affect the buoyancy of the PLB. Your PLB may not float if
items have been attached to it.
Figure 6.
Figure 7.
GPS Interface without holster
9
Y1-03-0174 Rev. E

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Terrafix 406 gps i/o plb

Table of Contents