Table of Contents
Advertisement
Land Pride
Section 8: Troubleshooting
Section 8:
Troubleshooting
Problem
Oil seal leaking
Power Take Off yoke
or shock cross failing
Slip Clutches slip even with a light load
Bent Power Take Off shaft (Note: Power
Take Off shaft should be repaired or
replaced if bent)
Power Take Off shaft
telescoping tube failing
Power Take Off shaft
telescoping tube wearing
Blades wearing excessively
Blades coming loose
Blades breaking
Loose blade carrier
Blade carrier bent
Excessive side skid wear
Excessive vibration
Wing cylinder movement too slow
8/28/08
Table of Contents
Solution
Drain to level fill hole
Replace seals
Clean off wrapped material and check seal areas daily
Avoid hitting solid objects
Lubricate every 8 hours
Replace clutch plates
Remove foreign object
Reduce lift height in transport position
Reposition drawbar
Shorten Power Take Off shaft
Avoid hitting solid objects
Lubricate every 20 hours of operation
Raise cutting height
Tighten blade hardware, refer to Service Cutting Blades in the "Maintenance and
Lubrication" section starting on page 25.
Avoid solid objects
Replace gearbox bearings and / or shaft
Tighten shaft nut to specified torque
Avoid hitting solid objects
Adjust cutter height
Raise cutting height
Replace Power Take Off or distribution shaft
Replace blade carrier
Replace blade
Inspect and unlock blades
Disassemble and inspect for incorrectly located needles or damaged bearing cap
Replace each pair of blades on affected carrier
Remove elbow fitting and remove orifice
RC5010 & RC6010 (540 RPM) and RCM5010 & RCM6010 (1000 RPM) Rotary Cutters 318-128M
41
Advertisement
Table of Contents
