4. Angle the controller to insert it into the bottom snap joints
of the back cover as shown in Figure 7.
Insert
Fig. 7 — Attach controller to back cover
5. Push the controller back toward the wall until it snaps into
place as shown in Figure 8.
Push
Fig. 8 — Snap controller into place
OPERATION
Turn the screen on —
or touch the Screen.
Fig. 9 — Turn screen on
ON/OFF setting —
Touch the "ON/OFF" icon to turn the
indoor unit on or off.
Fig. 10 — On/Off setting
WALL
WALL
Press the Screen ON/OFF icon
Setting the mode —
mode selection area to choose the mode.
Fig. 11 — Indoor Unit Operating Icon and LED
NOTES:
AUTO mode is unavailable when the wired controller is
connected to a heat pump system.
AUTO and DRY mode are unavailable when the wired
controller is connected to a VRF outside air unit.
Setting the fan speed —
visible until the IDU is turned on as shown in Figure 10. Touch
the corresponding fan speed text or the icon
fan speed. See Figure 12.
Fig. 12 — Fan Speed Setting
Optional fan speed modes include AUTO, HIGH, MED,
and LOW.
NOTES:
There is no AUTO fan speed when the wired controller is
connected to a VRF outside air unit. In DRY mode, the fan
speed is permanently set to AUTO.
Setting the temperature —
be visible until the IDU is turned on as shown in Figure 10. See
Figure 13.
Fig. 13 — Setting the temperature
5
Touch the "Mode" icon in the
The
icons will not be
to set the
The
icons will not