Canon PowerShot G1 Service Manual page 38

<Charge Adapter/Car Battery Cable Kit CR-560>
<Charge Adapter CG-560>
-Input voltage : DC 9.5 V
-Input current : DC 2.5A 2.7A (DC 9.5V, while charging the battery pack)
-Nominal output : Battery terminals : DC 8.4V 1.6A (while charging the BP-511)
DC OUT terminals : DC 8.4V 1.6A (with the adapter)
-Charging detection : Voltage/current detection by a microprocessor
-Charging time : BP-511: Approx. 80 min.
-Charging indications : No Battery Pack attached : Off
Battery Pack charging : Flashing in red
Charging completed : Lit up in red
Battery Pack malfunction : Flashing>>Off
-Terminal (DC IN) : Low type 3-pin special connector
-Operating temperature : 0 - 40C (32 - 104 F)
-Recommended temperature : 10 - 30 C (50 - 86 F)
-Dimensions : Approx. 93 X 36 X 71 mm
(WXHXD)
(3.7 x 1.4 x 2.8 in.)
-Weight : Approx. 140g (4.9 oz)
Fig. 5-7 Charge Adapter CG-560 dimensions (mm (in.))
<Car Battery Cable CB-560>
-Type
-Connectable cigarette
lighter socket
-Protection device
-Cable length
-Weight
Fig. 5-8 Car Battery Cable CB-560 dimensions (mm (in.))
<Wireless Controller WL-DC100>
-Type : Infrared
-Range : 5m (16.4 ft.) or longer (front, indoor)
-Directivity : Horizontal 15 degree 3m (9.8 ft.) or longer/
Vertical 15 degree 1m (3.3 ft.) or longer
-Battery : CR2025
-Power current consumption: 14mA +/- 10mA
-Stand by current : Max. 20µA
-Weight : Approx. 10 g (0.4 oz)
Fig. 5-9 Wireless Controller WL-DC100 dimensions (mm (in.))
: Car Battery Cable with a cigarette plug
: DC 12V/DC 24V, minus grounded (can be used in cars in most of countries.)
: Fuse (built-in 125V, 4A (factory preset))
: Approx. 1.8m (71.0 in.), with a special terminal on the other end.
: Approx. 80g (2.8 oz)
36 (1.4)
71
(2.8)
G32
93 (3.7)
B
B
B
A
35.0 (1.4)
6.5 (0.3)
32.0 (1.3)