Installing An Emx0 Pcie3 Expansion Drawer Into A Rack - IBM EMX0 PCIe Gen3 Installing

Figure 6. Attaching the rails
6. Move to the rear of the rack, and complete the following steps:
a) Extend the right rail, and insert the rail pins (D) into the two lowest mounting holes that are marked
on the rack. Rotate up the back clamp (C) to secure the rail in place.
b) Extend the left rail and insert the rail pins (D) into the two lowest mounting holes that are marked
on the rack. Rotate up the back clamp (C) to secure the rail in place.
c) Use two M5 screws (E), one below each rail pin (D) to secure the left rail to the back of the rack.
d) Use two M5 screws (E), one below each rail pin (D) to secure the right rail to the back of the rack.
7. Move to the front of the rack and complete the following steps:
a) Use one M5 screw (E) below the lower rail pin (D) to secure the left rail to the front of the rack.
b) Use one M5 screw (E), below the lower rail pin (D) to secure the right rail to the front of the rack

Installing an EMX0 PCIe3 expansion drawer into a rack

Find information about installing an EMX0 PCIe3 expansion drawer into a rack.
Before you begin
Important: Three people are required to safely lift the drawer. Using fewer than three people to lift the
drawer can result in injury.
10 Power Systems: Installing an EMX0 PCIe Gen3 I/O expansion drawer