Table of Contents
Advertisement
3
Obtaining an IP
Address
Automatically
Windows 2000
S
ETTING
The Gateway has the ability to dynamically allocate network addresses to
the computers on your network, using DHCP. However, your computers
need to be configured correctly for this to take place. To change the
configuration of your computers to allow this, follow the instructions in
this chapter. If your computers are configured with fixed or static
addresses and you do not wish to change this, then you should use the
Discovery program on the Gateway CD-ROM to detect and configure
your Gateway. Refer to
Discovery program.
If you are using a Windows 2000-based computer, use the following
procedure to change your TCP/IP settings:
1 From the Windows Start Menu, select Settings > Control Panel.
2 Double click on Network and Dial-Up Connections.
3 Double click on Local Area Connection.
4 Click on Properties.
5 A screen similar to
TCP/IP and click on Properties.
U
Y
P
OUR
Appendix A
for information on using the
Figure 6
should be displayed. Select Internet Protocol
C
OMPUTERS
Advertisement
Table of Contents
