Advertisement
Shaving
• Take off the foil protection cap
• For shaving, push the switch
• Hold the shaver at right angles (90°) to the skin.
• Stretch the skin with your free hand.
• Guide the shaver smoothly against the direction of
The pivoting cutting system (twin foil
integrated longhair cutter
your face automatically.
While shaving difficult parts of your face (e. g. under
the nose or at the hairline), push switch
«2», to lock the pivoting head at an angle.
5
Longhair trimmer
To activate the longhair trimmer, move the switch
to setting «3». The longhair trimmer moves upwards
and allows easy and exact trimming of the side
burns.
Switching the shaver off
Move the switch
Important: After every shave, put the foil protection
cap
6
9
.
4
to setting «1».
beard growth, applying only gentle pressure.
H
h
follows the contours of
4
4
back to setting «0».
9
on the pivoting head.
Switch the shaver off.
After each shave take off the triple shaving frame
Press the button
frame and pull it off.
Tap out slightly the triple shaving frame. Do not clean
the twin foil
and
Clean the duo cutterblock
brush.
Move the duo cutterblock crosswise and take it off.
Brush out the entire pivoting head area, including the
cutterblock base
cutterblock back into the cutterblock base
replace the triple shaving frame
place.
Approximately every four weeks clean the duo
to setting
cutterblock
After every cleaning replace the foil protection
9
cap
.
4
The triple shaving frame and duo cutterblock are
precision parts that will wear out over time. To
maintain optimal shaving performance you should
replace these parts when worn. This will ensure that
you continue to get the close, comfortable shave you
expect from your Braun shaver.
Important: Buy only original Braun spare parts,
especially when replacing the cord or the triple
shaving frame
frame look for the
obtain a perfect shave.
Triple shaving frame
«Cleaning and maintenance». Set the new triple
shaving frame on the pivoting head until it clicks into
place. Handle with care.
Duo-cutterblock
«Cleaning and maintenance». Place the new duo
cutterblock into the cutterblock base
into place.
8
j
to release the triple shaving
H
with the brush.
7
thoroughly with the
6
. After cleaning place the duo
6
and
8
until it clicks into
7
with Braun cleaning agents.
8
. When replacing the triple shaving
brand. Only this way you will
8
: Remove as described under
7
: Take as described under
6
until it clicks
Cleaning and maintenance
.
Purchasing spare parts
7
Advertisement
