Advertisement
4
Switch
Switch positions:
0 = Off (when not in use and always when charging)
1 = Shaving with the twin foil
2 = Shaving with the pivoting head locked at an
3 = The longhair trimmer
Switch lock
The shaver was delivered with the switch lock
activated (position «
to position «
avoid accidentally switching on the shaver, push the
switch lock to position «
Cordless shaving/charging
When charging the shaver for the first time, connect
it to the mains (100 - 240 V) and charge it for 4 hours
to full capacity. Then discharge the shaver through
normal shaving until the display
Recharge the shaver for at least 1 hour until the
black battery symbol appears in the display
This charging method preserves the maximum
capacity of the cell unit. All subsequent charges will
also take only 1 hour (quick charging). The full
capacity is reached after several charge/discharge
cycles. The shaver automatically adapts to all direct
and alternating current voltages (12 - 240 V) and to
frequencies of 50 or 60 Hz. Recharging on 12 V (–)
in cars or boats, takes approximately 20 hours. The
surrounding temperature should not exceed + 25 °C.
A full charge will give up to about 70 minutes of
cordless shaving (approximately 20 days based on
3.5 minutes per shave), depending on the thickness
of your beard.
4
H
and the integrated
h
longhair cutter
angle to permit shaving under the nose or at the
hairline
5
is activated
•
lock»). Push the switch lock
•
» before you shave for the first time. To
•
lock».
3
flashes.
The LCD displays
shaver and the rechargeable cell unit.
The rechergeable cell unit is discharged. The shaver
is not in operation.
The cell unit is charged between 0 and 99 %; the
shaver is connected to the mains and the plug
symbol is visible on the display with a green frame
2
. Should charging be interrupted during the
charging phase, the plug symbol flashes on the
display, thus reminding you to continue charging.
The shaver is connected to the mains – the plug
k
symbol is visible on the green framed display. After a
recharging time of approximately 1 hour, the battery
symbol is also visible on the green framed display.
The cell unit is recharged to 100 %.
The cell unit is charged between 100 and 20 %; the
shaver is not connected to the mains. Whether
switched on or off, the battery symbol is visible on the
green framed display.
The remainging charge in the cell unit is between 20
and 0 %. The shaver is switched on or off, however,
not connected to the mains. The battery symbol
flashes on the red framed display
the remainging charge – until the cell unit is fully
discharged.
2
.
In order to maintain the maximum capacity of the
rechargeable cell unit, it should be discharged about
every 6 months by shaving. Then fully recharged for
approximately 4 hours from the mains. Do not keep
the shaver connected to the mains for a long period
of time (i. e. several weeks).
Connect the shaver to the mains and turn the shaver
on (see switch
immediately – because of the discharged cell unit –
leave it plugged in with the switch
approximately 1 minute. Thereafter, you can shave
with cord plugged into the outled.
Notice: Shaving directly via the cord on voltages
below 100 V (in cars, boats etc.) is not possible.
2
3
and
show the state of the
3
– thus showing
4
). If the shaver should not run
4
set to «0», for
State of the shaver and
cell unit
Preserving the cell unit
Shaving with the cord
5
Advertisement
