Mobile Preset; Tel Mute - Kenwood KDC-6080R/RV Instruction Manual

NOTE
• This mode is available only when the Sound coordinate system
is on. (page29)
• You can call the following settings with this function; bass
centre frequency, bass level, bass quality factor, bass
extension, treble centre frequency, and treble level setting.
Their setting values are different depending on the setting of
the mobile preset plan mode.
"Bass"/"BAS" : Adjust the bass level.
Setting values: - 8 – + 8
"Treble"/"TRE" : Adjust the treble level.
Setting values: - 8 – + 8
"Balance"/"BAL" : Adjust the balance level.
Setting values: Left 15 – Right 15
"Fader"/"FAD" : Adjust the fader level.
Setting values: Front 15 – Rear 15
"V OFFSET/VOS" : Set the sound level of the each source
selected by adjusting the level difference
between the basic sound level and the
required level.
Setting values: - 8 – ± 0

Mobile Preset

This function allows you to adjust the setting that is recalled
with the sound coordinate system, according to types of
speakers.
1
Press the SRC button repeatedly to select the standby mode.
"ALL OFF" is displayed when the standby mode is selected.
2
Press the AUD button to enter the mobile preset plan mode.
3
Press either the 4 or ¢ button to select the type of
speaker. The setting switches as follows.
Off / For the OEM speaker / For 6/6x9 in. speaker /
For 5/4 in. speaker
4
Press the AUD button to end the mobile preset plan mode.
NOTE
• When you change the setting of type of speaker, the bass and
treble tone settings are returned to original levels.
• This mode is available only when the Sound coordinate system
is on. (page29)

TEL Mute

Shut down the audio system temporarily whenever an
incoming call is received.
NOTE
The function will not work if a cable is not connected to the car
phone.
When the telephone rings:
When a call is received, "CALL" is displayed and all the unit
functions are temporarily interrupted.
Restoring Original Unit Source During Phone Call:
Press the SRC button.
"CALL" disappears from the display, and the volume of the
original source is restored gradually.
Turning TEL Mute Function Off After Phone Call:
Hang the phone up.
"CALL" disappears from the display.
The original source (i.e., the one used before the phone call) is
returned to automatically, and the volume restored gradually.
— 9 —