Dimplex HL 185 T Installation And Operating Instructions page 4

5. Heating operation
Setting the operating mode
The following operating modes can be set with rotary switch A:
0 = Heating device off
I = Fan operation without heating
II = Heating and fan on. The red active light (C) illuminates.
Thermostat - Model: HL 185 T, HL 185/3
The room temperature is regulated using the infinitely
adjustable thermostat (B). If the rotary knob is set to the lowest
setting, the thermostat switches the heating device on at an
ambient temperature of approx. 5° C.
C A
Caution!
Rooms can become overheated if left unattended whilst being
heated; this depends on the size of the room, its heating
requirements and the setting of the thermostat. Persons who
are not able to vacate the room if the temperature becomes too
high can thus be placed in danger.
6. Protection against overheating
If the permissible temperature is exceeded, the heating device
switches off automatically. In this case, set the switch to
operating mode at "0" and allow the device to cool down
sufficiently so that the temperature limiter can switch back
again.
Then remove possible causes, e.g. when the air grid is blocked
or covered. When the device has cooled sufficiently, it can be
started up again.
7. Faults
If the heating device does not give off heat, check the following
points:
• Has the thermostat been set to the desired temperature?
• Has the overheat protection been triggered? See section 6!
• Is the fuse in the fuse box switched on?
If the fault cannot be corrected, please contact a specialist
electrical service center or else your nearest after-sales
service.
To process your order, please state the production number (E
No.) and manufacturing date (FD) of the device. This
information is listed on the type plate.
Repairs and corrective measures must only be carried out by a
qualified electrician or by your after-sales service.
Glen Dimplex Deutschland GmbH
Am Goldenen Feld 18
D-95326 Kulmbach
8. After-Sales Service
Robert Bosch Hausgeräte GmbH
Order service
Tel. +49 (0) 1801 22 33 55
Fax +49 (0) 1801 33 53 07
Spare parts ordering
Tel. +49 (0) 1801 33 53 04
Fax +49 (0) 1801 33 53 08
E-mail spareparts@bshg.com
Spare parts can be ordered online at:
http://www.dimplex.de
9. Cleaning
The device must be disconnected from the mains and allowed
B
to cool down before cleaning and maintenance. Clean the
outside of the unit using a soft, damp cloth. Do not use scouring
powder or furniture polish as this may damage the surface.
Dust which gathers inside the device can be removed from the
outside using a vacuum cleaner.
10. Warranty
This product is supplied with a two-year warranty according to
our terms of guarantee.
11. Note on Disposal
Do not dispose of the unit with general household
waste. The device must be taken to a local waste
disposal plant.
Tel. +49 (0) 9221 709 564
Fax +49 (0) 9221 709 589
E-mail: kundendienst.hauswaerme@glendimplex.de
4
Subject to technical changes
Internet: www.dimplex.de
hl185-en_ba 09/09/B