Main Unit - Kenwood XD-8551 Instruction Manual

Connection of parallel cord
÷ When connecting the parallel cord, insert plug straight into the
connector until it clicks to look them securely.
÷ When connecting the parallel cord, the wire while line should come
to the left side end.
÷ When disconnecting the parallel cord, push in the two sides of the
plug and pull it straight out.
4 4
Speaker (left)

Main unit

1
Twist
Speaker Unit
1
Twist
Caution regarding placement
(Front View)
The external view is variable depending
on the model and marketing destination
type.
Please install as shown below, as oth-
erwise fire may be caused by overheat-
ing.
From the top to the bottom
Amplifier
Tuner/Equalizer :C-H6 or C-H5
CD player
Cassette deck
2 3
2 3
To maintain proper ventilation,
be sure to leave a space around
the unit (from the largest outer
dimensions including projec-
tions) equal to, or greater than,
shown below.
top panel:
rear panel:
left and right panels: 10 cm
:A-H5
:DP-H5 or DP-MH5
:X-H5
1. Be sure to insert all connection
2. Before plugging or unplugging
3. When arranging the system
4
4. In case an associated system
5. Align the front panels of all sets
6. Never short-circuit the + and –
4
7. If the left and right speaker con-
System connection
XD SERIES (En/E2)
50 cm
10 cm
Notes Notes
cords securely. If their connec-
tions are imperfect, the sound
may not be produced or noise
may interfere.
a connection cord, be sure to
unplug the power cord from
the wall AC outlet. If connec-
tion cords are plugged or un-
plugged with the power cord
left plugged in, malfunction or
damage may result.
units in a vertical, stacked con-
figuration, observe the stack-
ing order indicated in the sys-
tem connection diagram.
component is connected, also
read the instruction manual of
the component.
flush.
speaker cords.
nections or the + and – polarity
are inverted, the sound will be
unnatural with unclear position-
ing of musical instruments, etc.
Be sure to connect them with-
out mistake.
7