Attaching The Weight Tower To The Movement Frame - Precor Discovery Selectorized Series Assembly Manual

Attaching the Weight Tower to the
Movement Frame
Note: Do not tighten fasteners until instructed to do so.
Have your assistant hold the movement frame in an upright, balanced position
while you complete the following procedure.
To attach the weight tower to the movement frame:
1. Locate the point where the cross support attaches to the weight tower.
Using a ⁵ ₁₆-inch hex bit and a 1-inch socket, remove the four bolts and two
domed washers.
2. Locate the point where the base support attaches to the weight tower.
Using a ⁷ ₃₂-inch hex bit and a ⁹ ₁₆-inch socket, remove the two bolts, four
washers, and two nuts installed there and set them aside.
3. Attach the base support to the weight tower using the fasteners removed
previously. Partially tighten the fasteners.
Figure 2: Base support attachment to weight tower
Shoulder Press Assembly Guide: Assembling the Equipment
4. Attach the cross support to the weight tower using the fasteners removed
previously. Partially tighten the fasteners.
Note: Be sure to orient the dome washers as shown in the following figure.
Figure 3: Cross support attachment to weight tower
4