Baby Monitor - Panasonic KX-TGF870 Series Operating Instructions Manual

7
MSAVEN a MOFFN
Base unit
1
MMENUN#238
2
MbN: Select the desired setting. a MSAVEN
R If you select "Off", press MEXITN to exit.
3
Enter the desired hour and minute you wish to
start this feature.
4
MAM/PMN: Select "AM" or "PM". a MOKN
5
Enter the desired hour and minute you wish to
end this feature.
6
MAM/PMN: Select "AM" or "PM".
7
MSAVEN a MEXITN
Changing the start and end time
Handset / Base unit
1
MMENUN#237
2
Continue from step 3 for handset or step 3 for
base unit, "Turning night mode on/off",
page 40.
Selecting groups to bypass night mode
Handset / Base unit
1
MMENUN#241
2
MbN: Select the desired groups. a MSELECTN
R " " is displayed next to the selected group
numbers.
R To cancel the selected group:
MbN: Select the group. a Press MSELECTN
again. " " disappears.
3
MSAVEN
4
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN

Baby monitor

This feature allows you to listen in on a room
where another handset is located, allowing you to
easily monitor from different areas of the house or
even while away from home. The monitored
handset (placed in a baby's room, for example) will
automatically call the monitoring handset, base
unit, or the phone number stored when it detects
sound.
For assistance, visit www.panasonic.ca/english/support
TGF87xC_(en)_0204_ver031.pdf 41
Important:
R Before using this feature, we recommend that
you test it and adjust the baby monitor
sensitivity as needed, especially if you plan to
monitor from outside.
R This feature should not be used as a substitute
for a medical or caregiver's supervision. It is the
caregiver's responsibility to stay close enough
to handle any eventuality.
Note:
R If the unit is connected to a PBX system, you
cannot set the baby monitor.
R During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset on
charger.
R The monitored handset never rings while it is
being monitored. If the base unit is placed near
the monitored handset, we recommend turning
off the base unit ringer volume (page 36).
Setting the baby monitor
Perform the setting operation with the handset to
be monitored (for example, the handset placed in
a baby's room).
To monitor with a unit
The internal baby monitor feature is available:
– between handsets
– between a handset and the base unit
Handset
1
MMENUN#268
2
MbN: "On" a MSELECTN
3
MbN: Select the desired unit's number to
monitor with. a MSAVEN
R "Baby monitor" will be displayed.
R The registered unit's name/number is
displayed.
Note:
R When this feature is on, another handset or the
base unit can hear the monitored handset by
making an intercom call.
To monitor from outside
If you enable this feature, the unit will call a
pre-programmed phone number when the handset
detects sound. After you answer the call, you can
listen in on the room where the handset is located.
Programming
41
2020/02/04 9:33:44