Bluetooth Connectivity - Bowers & Wilkins PI3 Manual

5. Bluetooth Connectivity

5.1 Pairing
Your Bowers & Wilkins PI3 earphones are designed to stream music wirelessly from Bluetooth audio
devices, such as smartphones, tablets, or computers. To do so, the earphones & device must first be paired.
1. The first time you switch on your earphones, Bluetooth pairing mode will be enabled, the indicator
will blink blue.
2. If pairing mode is not enabled, please hold the power button for 5 seconds, let go when the indicator
blinks blue & red, an audible cue will also be presented.
3. Ensure the Bluetooth feature is enabled on the device, your Bowers & Wilkins earphones will appear
in the discovery list, select it to start pairing.
4. The indicator will blink blue & red while pairing is in progress and will change to continuous blue &
an audible cue presented when successfully paired.
Your heapdhones can remember up to eight paired Bluetooth Devices. Repeat the above steps to pair
more devices.
Note: Your earphones will automatically exit Bluetooth pairing mode if no device is paired within 5
minutes. If pairing fails, the indicator will rapid flash blue, please try pairing again
5.2 Switching Between Two Connected Devices
Your earphones can connect up to two devices at the same time. However, you can only play audio or take
calls from one device at a time.
To switch between two devices:
1. Pause audio on the first device, or use the earphone's play/pause button.
2. Play audio from the second device and the earphone will switch over.
When streaming audio, receiving a call on the second device will automatically pause playback and the call
will be routed automatically to your earphones. Ending the call will automatically resume playback from the
first device.
9